智能车制作

标题: CW5.1 烧写程序出错 [打印本页]

作者: herohxb 时间: 2015-10-28 10:10
标题: CW5.1 烧写程序出错
   MCU clock speed: 4000000 Hz
Block Module Name    Address Range Status
0  PFLASH          4000 -  7FFF Programmed - Unselected
1  PFLASH          C000 -  FFFF Programmed - Unselected
2  PFLASH       E08000 -E7BFFF Programmed - Unselected
3  PFLASH       F88000 -FFBFFF Programmed - Unselected
4  DFLASH          800 -1F0BFF Programmed - Unselected

FP: The UNPROTECT command is not available for the PFLASH flash module => Skipped.

FP: The UNPROTECT command is not available for the PFLASH flash module => Skipped.

FP: The UNPROTECT command is not available for the PFLASH flash module => Skipped.

FP: The UNPROTECT command is not available for the PFLASH flash module => Skipped.

FP: The UNPROTECT command is not available for the DFLASH flash module => Skipped.
executing .\cmd\TBDML_vppon.cmd

!// Before programming the flash, the commands written below will be executed
done .\cmd\TBDML_vppon.cmd

Vppon command file correctly executed.

FP: Operation failed on PFLASH flash module.

FP: Operation failed on PFLASH flash module.

FP: Operation failed on PFLASH flash module.

FP: Operation failed on PFLASH flash module.

FP: Operation failed on DFLASH flash module.
executing .\cmd\TBDML_vppoff.cmd

!// After programming the flash, the commands written below will be executed
done .\cmd\TBDML_vppoff.cmd

Vppoff command file correctly executed.
FP: Arm FLASH for loading.
executing .\cmd\TBDML_vppon.cmd

!// Before programming the flash, the commands written below will be executed
done .\cmd\TBDML_vppon.cmd

Vppon command file correctly executed.
executing .\cmd\TBDML_vppoff.cmd

!// After programming the flash, the commands written below will be executed
done .\cmd\TBDML_vppoff.cmd

Vppoff command file correctly executed.
FP: FLASH disarmed.
executing .\cmd\TBDML_reset.cmd

!// After reset the commands written below will be executed
done .\cmd\TBDML_reset.cmd

Reset command file correctly executed.
executing .\cmd\TBDML_postload.cmd

!// After load the commands written below will be executed
RESET
done .\cmd\TBDML_postload.cmd

Postload command file correctly executed.
Error: Loading failed!

in>

已经困扰我好久了，我尝试过解锁，能解锁；但每次解完，就显示"unable to connect to target CPU"，求大神指点！！！！！！！！！

欢迎光临智能车制作 (http://dns.znczz.com/)